Auto Serwis Wadowicka offers a range of services related to the geometry of car suspension. Our factory checks and sets the geometry and alignment of wheels in all makes and models of cars. Diagnostics are performed using a wireless computer interface.
In addition, we repair and replace other elements of the steering system - steering gears, rods, tips, power steering pumps and cables. Have you noticed the car pulling to the left or right when you let go of the steering wheel while driving on a straight road? Do not hesitate and go to our service - it will probably be necessary to set the suspension geometry correctly. Incorrect geometry leads to tire wear.
You should have the wheel alignment checked by computer if:
- Irregular tire wear has caught your eye;
- you are having trouble driving or maneuvering a vehicle;
- you hit an obstacle with a wheel;
- the vehicle is skidding or pulling;
- the steering wheel does not return to its neutral position after a turn;
- the steering wheel is turned and the vehicle is still going straight;
- you bought new tires and don't want to replace them soon;
- you have replaced a part of the steering or suspension.
The following factors contribute to the correct geometry of the wheels:
Convergence
A parameter that determines the position of the front and rear wheels relative to each other. When toe is misaligned, excessive tire wear occurs. It is also especially dangerous when cornering or when driving on wet surfaces, where there is a chance of uncontrolled skidding.
Tilt angle
Angle of the wheel as seen from the front of the vehicle. Excessive inclination also leads to uneven tire wear. The correct angle of inclination should be set so that the wheels are flat against the ground when turning.
Knuckle caster angle
Angle between the axis of the king pins and the vertical line in both wheels. Unequal alignment of the wheels in relation to each other can result in a curvature of the steering wheel and a pulling effect when braking and driving.
On our website, we perform diagnostics wheel alignment geometry, and if necessary, we perform computer alignment. The work of our technicians can include both front axle alignment and rear axle alignment. Remember, if you have replaced the control arm or tie rod end, you must set toe, also after replacing the shock absorbers. Otherwise, you'll notice uneven tire wear.
If you are looking for laser convergence setting, you care about high professionalism, please visit our website.